Cisco Small Business 200 Series

Using the Command Line Interface
Command Syntax
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 15
1
Command Syntax
A command is one or more words that might include one or more parameters.
Parameters might be required or optional values.
Some commands, such as
show network or clear vlan, do not require parameters.
Other commands, such as
network parms, require that you supply a value after the
command. You must type the parameter values in a specific order. Optional
parameters follow required parameters. The following example describes the
network parms command syntax:
network parms ip-address netmask [gateway]
• network parms is the command name.
•
ip-address and netmask are mandatory parameters that you must replace with
the actual value.
•
gateway is an optional parameter that you can replace with text.
This reference lists each command by the command name and provides the
following information where applicable:
• Syntax Descriptions—describes each keyword and parameter.
• Defaults—describe any default values for the command parameters.
• Command Modes—identifies the CLI command modes in which you can
execute the command.
• Examples—one or more examples of the command string, the output, and
descriptions of the output fields, if applicable.
• Related Commands—other commands you can use in conjunction with the
primary command.