Cisco Small Business 200 Series

Port Management
Flow Control and Storm Control
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 193
3
storm-control multicast rate
This command enables and configures the multicast storm recovery threshold for
an interface or all interfaces as packets per second. If multicast storm recovery is
active, and if the rate of Layer 2 broadcast traffic ingressing on an interface
increases beyond the configured threshold, the traffic is dropped.
Use the no form of command to remove the rate threshold. In Global Config mode
the same rate is set on all ports.
storm-control multicast rate 0-14880000
no storm-control multicast rate
Syntax Descriptions
Default
No rate is configured.
Command Modes
Interface Config
Global Config
storm-control
multicast level
Configures the multicast storm recovery threshold for an
interface or all interfaces.
show storm-
control
Shows storm control configuration on a port or on all ports.
Parameter Description
0–14880000 The multicast traffic rate, in number of packets per second,
above which traffic will be dropped.
Command Description