Cisco Small Business 200 Series

11
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 415
SNMP
This chapter describes how to use the CLI commands to configure the Simple
Network Management Protocol (SNMP) on the switch.
snmp-server community
This command adds and names a new SNMP community. A community name is a
name associated with the switch and with a set of SNMP managers that manage it
with a specified privileged level (read or write).
NOTE Community names in the SNMP Community Table must be unique. When making
multiple entries using the same community name, the first entry is kept and
processed and all duplicate entries are ignored.
The maximum number of communities that can be configured is 8.
Use the no form of the command to remove this community name from the table.
snmp-server community name {ro | rw} [ipaddress ip-address]
no snmp-server community name
Syntax Descriptions
Parameter Description
name The name to assign to the community, up to 16 case-
sensitive characters.
ro | rw ro—Read Only access.
rw—Read/Write access.
ipaddress The IP address that users must have to gain SNMP access
through this community. If no value is specified, access is
permitted from any IP address.