Cisco Small Business 200 Series

Administration
Syslog
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 136
2
Syntax Descriptions
Command Modes
Privileged EXEC
Examples
The following example saves the startup log in flash to a TFTP server location and
names the file.
(switch) #copy nvram:startup-log version 1 tftp://10.12.17.182/logs/
startuplog06-24-10.txt
Mode........................................... TFTP
Set Server IP.................................. 10.12.17.182
Path........................................... logs/
Filename....................................... startuplog06-24-10.txt
Data Type...................................... Startup Log
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n)y
Parameter Description
source source can be:
• nvram:startup-log version x—This is the startup
persistent log.
• nvram:operational-log version x—This is the
operational persistent log.
Where x is the version of the startup or operational log,
and can be 1, 2 or 3. If version is not specified, then version
current version (version 1) is used.
destination destination can be:
{xmodem | tftp}://{ip-address | hostname}/filepath/
filename}.
For TFTP, the {ip-address | hostname} parameter is the IP
address or hostname of the server, filepath is the path to
the file, and filename is the name of the file you want to
give to the file when it is saved.