Cisco Small Business 200 Series

Administration
RMON
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 168
2
Related Commands
Undersize The number of packets received during this sampling
interval that were fewer than 64 octets (excluding framing
bits but including FCS octets) and were otherwise well-
formed.
Oversize The number of packets received during this sampling
interval that were longer than 1518 octets (excluding
framing bits but including FCS octets) but were otherwise
well-formed.
Fragments The total number of packets received during this sampling
interval that were fewer than 64 octets (excluding framing
bits but including FCS octets) had either a bad Frame Check
Sequence (FCS) with an integral number of octets (FCS
Error), or a bad FCS with a non-integral number of octets
(AlignmentError). It is normal for etherHistoryFragments to
increment because it counts both runts (which are normal
occurrences due to collisions) and noise hits.
Jabbers The number of packets received during this sampling
interval that were longer than 1518 octets (excluding
framing bits but including FCS octets), and had either a bad
Frame Check Sequence (FCS) with an integral number of
octets (FCS Error) or a bad FCS with a non-integral number
of octets (Alignment Error).
Dropped The number of events in which packets were dropped by
the probe due to lack of resources during this sampling
interval. This number is not necessarily the number of
packets dropped. It is just the number of times this condition
has been detected.
Collisions The best estimate of the total number of collisions on this
Ethernet segment during this sampling interval.
Command Description
show rmon
events
Displays the RMON event table.
show rmon
collection history
Displays the requested group of statistics.