Cisco Small Business 200 Series

Using the Command Line Interface
Command Modes
Cisco Small Business 200E Series Advanced Smart Switch Command Reference 19
1
The following table explains how to enter and exit each mode.
Line Console
Config
switch (config-line)# Outbound telnet settings and
console interface settings,
including console login and
authentication information.
Line SSH Config switch (config-ssh)# SSH login and authentication
information.
Line Telnet Config switch (config-telnet)# Telnet login and authentication
information.
Mode To Enter To Exit
Privileged EXEC Users enter this mode
when they log in.
To log out of the CLI session, enter
quit.
Global Config From the Privileged
EXEC mode, enter
configure or config.
To exit to the Privileged EXEC
mode, enter exit, or press Ctrl-Z.
VLAN Config From the Privileged
EXEC mode, enter
vlan database.
To exit to the Privileged EXEC
mode, enter exit or press Ctrl-Z.
Interface Config From the Global
Config mode, enter
interface interface
To exit to the Global Config mode,
enter exit. To return to Privileged
EXEC mode, enter Ctrl-Z.
Access List
Config
From the Global
Config mode, enter
management
access-list listname
To exit to the Global Config mode,
enter exit. To return to Privileged
EXEC mode, enter Ctrl-Z.
Line Console From the Global
Config mode, enter
line console.
To exit to the Global Config mode,
enter exit. To return to Privileged
EXEC mode, enter Ctrl-Z.
Line SSH From the Global
Config mode, enter
line ssh.
To exit to the Global Config mode,
enter exit. To return to Privileged
EXEC mode, enter Ctrl-Z.
Command Mode Prompt Description