INSTALLATION
(1) Install and loose assemble the front resonator
to the converter pipes.
(2) Place the exhaust system on two supports (one
on side of muffler, one behind the resonator). Connect
the system to the converter pipes.
(3) Install the system’s rubber isolators onto the
support brackets.
(4) Install exhaust system ground strap.
(5) Visually inspect the isolators. They should be
straight when viewing from front to back of the vehi-
cle. Working from the front of system, align each
component to maintain position and proper clearance
with underbody parts.
(6) Tighten band clamps to the proper torque.
(7) Lower the vehicle.
MUFFLER AND FRONT RESONATOR
REMOVAL
(1) Remove exhaust system. Refer to procedure in
this section.
Fig. 4
Rubber Isolator Hanger to Body Support Bracket
1 – SUPPORT BRACKET
2 – ISOLATOR
3 – RESONATOR/PIPE
Fig. 5 Exhaust Module Supports
1 – SUPPORTS
2 – MUFFLER
3 – ISOLATORS
LH EXHAUST SYSTEM 11 - 5
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
