Chrysler 2000 LHS - Trunk Lamp Bulb; Chmsl - 300 M; CHMSL - Intrepid; Tail, Stop, Back Up, and Turn Signal Lamp Bulb

CHMSL LAMP BULB – 300M
REMOVAL
(1) Release decklid latch and open decklid.
(2) Remove decklid cover.
(3) Disconnect lamp socket(s) from housing (Fig.
11).
(4) Remove bulb(s) from socket(s).
INSTALLATION
(1) Install bulb(s) in socket(s).
(2) Install socket(s) into housing.
(3) Verify CHMSL operation.
(4) Install decklid cover.
TRUNK LAMP BULB
REMOVAL
(1) Remove lens from lamp from the rear shelf
(Fig. 12).
(2) Pull bulb from socket.
INSTALLATION
(1) Insert bulb into socket.
(2) Install lamp lens.
TAIL, STOP, BACK UP, AND TURN SIGNAL
LAMP BULB
REMOVAL
(1) Release decklid latch and open decklid.
(2) Remove trunk lining from rear closure panel as
necessary to gain access to tail lamp fasteners.
(3) Remove nuts attaching tail lamp to rear clo-
sure panel.
(4) Remove tail lamp from rear closure panel.
(5) Remove socket(s) from tail lamp (Fig. 13), (Fig.
14), and (Fig. 15).
(6) Pull bulb from socket.
Fig. 10 CHMSL – Intrepid
1 – TRUNK LID APPLIQUE AND CHMSL
2 – BODY WIRING AND LAMPS
3 – PLASTIC HEX NUT
Fig. 11 CHMSL – 300M
1 – CHMSL LAMP
2 – TRUNK LID LOWER EDGE
Fig. 12 Trunk Lamp Bulb
1 – BULB
2 – TRUNK LAMP SOCKET
3 – REAR SHELF
4 – LENS
8L - 16 LAMPS LH
REMOVAL AND INSTALLATION (Continued)