(3) From the engine compartment, hold the throt-
tle body lever in the wide open position and install
the throttle cable.
THROTTLE CABLE
CAUTION: When servicing the accelerator pedal,
throttle cable or speed control cable, do not dam-
age or kink the core wire inside the cable sheath-
ing.
REMOVAL
(1) Working from the engine compartment, hold
the throttle body throttle lever in the wide open posi-
tion. Pull the cable forward and slide it out of the
throttle body cam.
(2) From inside the vehicle, hold up the pedal and
remove the cable retainer and throttle cable from the
upper end of the pedal shaft (Fig. 30).
(3) Remove retainer clip from throttle cable and
grommet at dash panel (Fig. 31).
(4) From the engine compartment, pull the throttle
cable out of the dash panel grommet. The grommet
should remain in the dash panel.
(5) Remove the throttle cable from throttle bracket
by carefully compressing both retaining ears simulta-
neously. Then gently pull the throttle cable from
throttle bracket.
Fig. 30 Accelerator Pedal and Throttle Cable
Fig. 31 Retainer Clip
Fig. 32 Accelerator Pedal Removal/Installation
1 – MOUNTING NUTS
2 – ACCELERATOR PEDAL
Fig. 33 Carpet and Insulation Placement
1 – PEDAL BASE
2 – CARPET
3 – INSULATION
4 – FLOOR PAN
14 - 18 FUEL SYSTEM LH
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
