Chrysler 2000 LHS - Arm Rest Removal; Arm Rest with Ski Pass; Rear Seat Back - 60 Section; Rear Seat Silencer

INSTALLATION
(1) Place seat back 40 section on pin.
(2) Install bolt attaching 40 section seat back to
collar section. Tighten bolt to 16 N·m (12 ft. lbs.)
torque.
(3) Place seat back collar assembly in position in
vehicle.
(4) Install nuts attaching seat back collar assem-
bly. Tighten nuts to 40 N·m (29 ft. lbs.) torque.
(5) Install seat cushion.
REAR SEAT BACK – 60 SECTION
REMOVAL
(1) Open door.
(2) Remove rear seat cushion.
(3) Remove nuts attaching seat back collar assem-
bly.
(4) Remove seat back collar assembly.
(5) Remove bolt attaching 40 seat section.
(6) Remove the 40 seat section.
(7) Remove bolt attaching 60 seat section (Fig. 27).
(8) Slide seat back 60 seat section off pivot bracket
and remove from the collar assembly.
INSTALLATION
(1) Install the 60 seat section on pivot bracket.
(2) Install bolt attaching 60 seat section. Tighten
bolt to 16 N·m (12 ft. lbs.) torque.
(3) Install the 40 seat section on pin.
Fig. 20 Arm Rest with Ski Pass
1 – SKI PASS
2 – DOOR
Fig. 21 Rear Seat Silencer
1 – FASTENERS
2 – SKI PASS
Fig. 22 Rear Seat Arm Rest With Ski Pass
1 – FASTENERS
Fig. 23 Arm Rest Removal
1 – ARM REST WITH SKI PASS
23 - 18 BODY LH
REMOVAL AND INSTALLATION (Continued)