HEADLAMP WASHER PUMP
Removal
(1) Open hood and disconnect the negative battery
cable remote terminal from the battery post.
(2) Hoist vehicle.
(3) Drain washer fluid into a clean container.
(4) Partially remove the front fascia to gain access
to the windshield/headlamp washer pump. Refer to
Group 23, Body for Removal and Installation proce-
dures.
(5) Remove the four windshield/headlamp washer
reservoir mounting bolts.
(6) Pull the reservoir away from body to gain
access to the headlamp washer pump.
(7) Disconnect the headlamp washer pump electri-
cal connector and the headlamp washer pump hose.
(8) Pull the headlamp washer pump from the res-
ervoir.
Installation
(1) Install the headlamp washer motor in the
windshield/headlamp washer pump.
(2) Connect the headlamp washer pump hose and
electrical connector.
(3) Install the reservoir retaining bolts. Torque
bolts to 5 to 7 N·m.
(4) Reinstall the front fascia as necessary. Refer to
Group 23, Body for Removal and Installation proce-
dures.
(5) Lower vehicle from hoist.
(6) Refill the windshield/headlamp washer reser-
voir.
(7) Reconnect the negative battery cable remote
terminal.
(8) Prime the headlamp washer system. Refer to
the Headlamp Washer Priming Procedure in this sec-
tion.
Fig. 8 Headlamp Washer Pump
1 – WINDSHIELD/HEADLAMP WASHER RESERVOIR
2 – HEADLAMP WASHER PUMP
LH WIPER AND WASHER SYSTEMS 8K - 7
REMOVAL AND INSTALLATION (Continued)
2000 LHS, 300M, CONCORDE AND INTREPID
To Next Page
Loading...
