Chrysler 2000 LHS - CHMSL - Decklid; CHMSL Housing - Intrepid

(4) Verify CHMSL operation.
(5) Install decklid cover.
TAIL, STOP, BACK UP, AND TURN SIGNAL
LAMP
REMOVAL
(1) Release decklid latch and open decklid.
(2) Remove fasteners attaching trunk lining to
lower rear trunk panel.
(3) Move the trunk lining to access the tail lamp
fasteners.
(4) Remove nuts attaching tail lamp to lower
trunk and quarter panel (Fig. 16), and (Fig. 17).
(5) Remove tail lamp from vehicle.
(6) Disconnect tail lamp wire connector from body
wire harness.
INSTALLATION
(1) Connect tail lamp wire connector to body wire
harness.
(2) Place tail lamp in position on vehicle.
(3) Install nuts to attach tail lamp to lower trunk
and quarter panel.
(4) Place trunk lining in position on lower trunk
panel.
(5) Install fasteners to attach trunk lining to lower
rear trunk panel.
(6) Verify lamp operation.
Fig. 14 CHMSL Housing – Intrepid
1 – TRUNK LID APPLIQUE AND CHMSL
2 – BODY WIRING AND LAMPS
3 – PLASTIC HEX NUT
Fig. 15 CHMSL – Decklid
1 – CHMSL LAMP
2 – TRUNK LID LOWER EDGE
Fig. 16 Tail, Stop, Back up, and Turn Signal –
Concorde/LHS
1 – PLASTIC HEX NUT (4)
2 – TAIL LAMP
LH LAMPS 8L - 23
REMOVAL AND INSTALLATION (Continued)