LUBRICATION AND MAINTENANCE
TABLE OF CONTENTS
page page
LUBRICANTS ............................. 1
MAINTENANCE SCHEDULES ................. 3
JUMP STARTING, TOWING, AND HOISTING..... 9
LUBRICANTS
TABLE OF CONTENTS
page page
SERVICE PROCEDURES
PARTS AND LUBRICANT
RECOMMENDATIONS ....................1
CLASSIFICATION OF LUBRICANTS............1
INTERNATIONAL SYMBOLS .................2
FLUID CHECK/FILL POINTS AND
LUBRICATION LOCATIONS.................2
LUBRICATION POINT LOCATIONS ............2
SPECIFICATIONS
FLUID CAPACITIES ........................2
SERVICE PROCEDURES
PARTS AND LUBRICANT RECOMMENDATIONS
When service is required, DaimlerChrysler Motor
Corporation recommends that only Mopart brand
parts, lubricants and chemicals be used. Mopar pro-
vides the best engineered products for servicing
DaimlerChrysler Corporation vehicles.
ENGINE COOLANT
The green and the orange engine coolant MUST
NOT BE MIXED. When replacing coolant the com-
plete system flush must be performed before using
the replacement coolant.
CLASSIFICATION OF LUBRICANTS
Only lubricants bearing designations defined by
the following organization should be used to service a
DaimlerChrysler Corporation vehicle.
• Society of Automotive Engineers (SAE)
• American Petroleum Institute (API) (Fig. 1)
• National Lubricating Grease Institute (NLGI)
(Fig. 2)
SAE VISCOSITY RATING
An SAE viscosity grade is used to specify the vis-
cosity of engine oil. Engine oils also have multiple
viscosities. These are specified with a dual SAE vis-
cosity grade which indicates the cold-to-hot tempera-
ture viscosity range.
• SAE 30 = single grade engine oil.
• SAE 10W-30 = multiple grade engine oil.
DaimlerChrysler Corporation only recommends
multiple grade engine oils.
API QUALITY CLASSIFICATION
This symbol (Fig. 1) on the front of an oil container
means that the oil has been certified by the Ameri-
can Petroleum Institute (API) to meet all the lubri-
cation requirements specified by DaimlerChrysler
Corporation.
Refer to Group 9, Engine for gasoline engine oil
specification.
GEAR LUBRICANTS
SAE ratings also apply to multiple grade gear
lubricants. In addition, API classification defines the
Fig. 1 API Symbol
LH LUBRICATION AND MAINTENANCE 0 - 1
To Next Page
Loading...
Need help?
General
