Chrysler 2000 LHS - EGR Valve; EGR Tube and Valve

INSTALLATION
(1) Loosely install EGR valve and new gasket on
cylinder head.
(2) Using a new gasket, loosely install the EGR
tube and mounting screws..
(3) Tighten EGR valve to cylinder head screws to
31 N·m (275 in. lbs.) torque.
(4) Tighten the EGR tube to EGR valve screws to
11 N·m (95 in. lbs.) torque.
(5) Attach electrical connector to solenoid.
(6) Install air inlet tube and resonator.
(7) Connect negative battery cable.
EGR TUBE UPPER—2.7L
The EGR tube attaches to the intake manifold ple-
num on both sides of the throttle body and the EGR
valve.
REMOVAL
(1) Disconnect negative battery cable.
(2) Remove air inlet tube and resonator.
(3) Remove throttle cable bracket and reposition.
(4) Remove EGR tube mounting screws at intake
manifold plenum (Fig. 4).
(5) Remove EGR tube mounting screws at EGR
valve.
(6) Remove EGR upper tube.
Fig. 1 EGR Valve—2.7 L
Fig. 2 EGR tube and Valve
1 – EGR TUBE
2 – EGR VALVE
Fig. 3 EGR Tube—2.7L
Fig. 4 EGR Tube at Intake Manifold
1 – PCV VALVE
2 – THROTTLE BODY
3 – EGR TUBE
25 - 28 EMISSION CONTROL SYSTEMS LH
REMOVAL AND INSTALLATION (Continued)