Chrysler 2000 LHS User Manual

FRAME AND BUMPERS
FRAME
TABLE OF CONTENTS
page page
REMOVAL AND INSTALLATION
FRONT LICENSE PLATE BRACKET............1
FRONT TOW HOOK BRACKET ...............1
REAR TOW HOOK BRACKET ................2
REMOVAL AND INSTALLATION
FRONT LICENSE PLATE BRACKET
REMOVAL
(1) Remove the license plate from the bracket.
(2) Remove the license plate bracket attaching
screws (Fig. 1).
(3) Remove the license plate bracket from the front
bumper fascia.
INSTALLATION
(1) Position the license plate bracket on the front
bumper fascia.
(2) Install the attaching screws.
(3) Install the license plate on the license plate
bracket.
FRONT TOW HOOK BRACKET
REMOVAL
(1) Remove the tow hook from the tow hook
bracket.
(2) Open hood and disconnect the negative battery
cable remote terminal from the battery post.
(3) Hoist vehicle.
(4) Partially remove the front fascia to gain access
to the windshield/headlamp washer reservoir. Refer
to Group 23, Body for Removal and Installation pro-
cedures.
(5)
Remove the tow hook bracket mounting fasteners.
(6) Remove the tow hook bracket (Fig. 2).
Fig. 1 Front License Plate Bracket
1 – FRONT BUMPER FASCIA
2 – FRONT LICENSE PLATE BRACKET
3 – FRONT LICENSE PLATE BRACKET ATTACHING SCREWS
Fig. 2 Front Tow Hook Bracket
1 – FRONT TOE HOOK
2 – FRONT TOE HOOK BRACKET
LH FRAME AND BUMPERS 13 - 1
2000 LHS, 300M, CONCORDE AND INTREPID

Chrysler 2000 LHS Specifications

General

Brand	Chrysler
Model	2000 LHS
Category	Automobile
Language	English