Chrysler 2000 LHS - Side Repeater Lamp Retaining Tabs; Side Repeater Lamp Bulb; Side Repeater Lamp; Front Fog Lamp Assembly Rear Cover

Installation
(1) Install bulb into the fog lamp assembly and
reattach the retaining wire.
(2) Cover exposed terminals with protective sleeve.
(3) Install the rear cover on the fog lamp assembly.
(4) Connect the electrical connector and place the
fog lamp assembly into the front bumper fascia.
(5) Install the fog lamp assembly attaching screws.
SIDE REPEATER LAMP BULB
Removal
(1) Insert a small flat screwdriver between the
lamp and the body panel. Disengage the lamp retain-
ing tabs (Fig. 11) (Fig. 12).
Fig. 9 Front Fog Lamp Assembly Rear Cover
1 – FRONT FOG LAMP ASSEMBLY
2 – FRONT FOG LAMP ASSEMBLY REAR COVER
Fig. 10 Front Fog Lamp Bulb
1 – FRONT FOG LAMP ASSEMBLY
2 – FRONT FOG LAMP BULB
Fig. 11 Side Repeater Lamp
1 – SIDE REPEATER LAMP
2 – FENDER
Fig. 12 Side Repeater Lamp Retaining Tabs
1 – RETAINING TABS
2 – REPEATER LAMP
3 – FENDER
LH LAMPS 8L - 11
REMOVAL AND INSTALLATION (Continued)
2000 LHS, 300M, CONCORDE AND INTREPID