(1) Tighten multi-function switch retaining screws
to 17 in. lbs. (2 N·m) torque.
WASHER FLUID LEVEL SENSOR
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 6).
(2) Hoist vehicle.
(3) Remove front fascia as necessary (left side only
and use a 2x4 to prop left edge of fascia away from
body). Refer to Group 23, Body for Removal and
Installation procedures.
(4) Disconnect the wire connector from the reser-
voir fluid level sensor.
(5) Gently pry sensor away from reservoir and out
of grommet. Care must be taken not to puncture res-
ervoir (Fig. 10).
(6) Remover rubber grommet from reservoir and
throw away.
INSTALLATION
For installation, reverse the above procedures.
NOTE: Use a new mounting grommet when install-
ing a new sensor assembly.
Assure “flat” of sensor is aligned under the “ridge”
of reservoir and that sensor connector is facing down
in the fully seated position.
WASHER FLUID LEVEL SENSOR (INTREPID)
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Remove the Washer Reservoir. Refer to Washer
Reservoir Removal and Installation in this section
(3) Gently pry sensor away from reservoir and out
of grommet. Care must be taken not to puncture res-
ervoir (Fig. 10).
(4) Remover rubber grommet from reservoir and
throw away.
INSTALLATION
For installation, reverse the above procedures.
NOTE: Use a new mounting grommet when install-
ing a new sensor assembly.
Assure “flat” of sensor is aligned under the “ridge”
of reservoir and that sensor connector is facing down
in the fully seated position.
WASHER HOSE
REMOVAL
(1) Remove left headlamp module. Refer to Group
8L, Lamps for Removal and Installation procedures.
(2) Remove underhood silencer pad clips only
along left rear of hood.
(3) Carefully pull silencer pad away from hood.
(4) Disconnect “Y” connector from hood.
(5) Disconnect right and left hood nozzle hoses at
“Y” connector.
Fig. 6 Negative Battery Cable Remote Terminal
1 – RIGHT STRUT TOWER
2 – AIR CLEANER INLET TUBE
3 – REMOTE TERMINAL
Fig. 7 Multi-Function Switch
1 – MULTIFUNCTION SWITCH
2 – MOUNTING SCREW
3 – WIRING HARNESS
4 – STEERING COLUMN
5 – MOUNTING SCREW
LH WIPER AND WASHER SYSTEMS 8K - 13
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
