REMOVAL AND INSTALLATION
ATC IN-CAR TEMPERATURE SENSOR
The In-car Temperature Sensor is part of the ATC
Control Head and not a separate service part. If
defective, the complete ATC head must be replaced.
ATC SUN SENSOR
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 22).
(2) Remove the instrument upper/top cover. Refer
to Instrument Panel Upper/Top Cover Removal and
Installation in this section, (Fig. 8), (Fig. 9) and (Fig.
10).
(3) Remove the two sun sensor mounting screws.
(4) Disconnect the wire connector and remove the
sensor (Fig. 7).
INSTALLATION
For installation, reverse the above procedures
Fig. 6 ATC In-Car Temperature Sensor
1 – ATC IN-CAR TEMPERATURE SENSOR
Fig. 7 ATC Sun Sensor
8E - 4 INSTRUMENT PANEL SYSTEMS LH
To Next Page
Loading...
