SUNROOF OPERATION
DESCRIPTION
WARNING: Keep fingers and other body parts out
of sunroof opening at all times.
The sunroof features a power sliding glass panel
and a sunshade which can be manually positioned
anywhere along its travel, rearward of glass panel
front edge.
OPERATION
The sunroof is electrically operated from a two
switches located on the windshield header, rearward
of the map lamp. To operate the sunroof the ignition
switch must be in the On/Run position. One switch
(CLOSE) is a push button type and used too close the
sunroof. Pressing and holding the CLOSE button, the
sunroof will fully close. If the CLOSE button is
released prior to the sunroof reaching the fully closed
position, the sunroof will stop in that position. The
other switch (OPEN/VENT) is a rocker type for open-
ing and venting the sunroof. Pressing and releasing
the OPEN button once the sunroof will express open
and the wind deflector will raise. If the button is
pressed a second time the sunroof will stop in that
position. To open the sunroof from the vent position,
push and hold the open button. The sunroof will not
express open until you have passed through the full
closed position. The OPEN button may be released
and the sunroof will continue to open in the express
open feature. If the VENT button is pressed and held
while the sunroof is in the open position, the sunroof
will travel to the close position and then to the vent
position. Releasing the button at anytime during the
travel will cause the sunroof to stop at that current
position.
LH BODY 23 - 3
DESCRIPTION AND OPERATION (Continued)
To Next Page
Loading...
Need help?
General
