Chrysler 2000 LHS - Rear Housing Hose; Sunroof Housing Drain Hose

(5) Slide the sunshade forward while lifting the
front through the opening until the rear guide blocks
are accessible.
CAUTION: Use care not to crease the sunshade
when removing or installing.
(6) Disengage rear guide blocks from track.
INSTALLATION
(1) Install the sunshade from outside of the vehicle
with the sunroof 90% open.
(2)
Put rear guide blocks into sunshade guide track.
(3) Push sunshade back and down through the
sunroof opening.
(4) Using a flat blade tool, put front guide blocks
into the sunshade track. By pushing the block
towards the center of the vehicle.
(5) Push sunshade back to the glass panel.
(6) Push sunshade down until the sunshade clears
the glass then move sunshade rearward behind the
glass panel.
SUNROOF HOUSING DRAIN HOSE
FRONT HOSES
REMOVAL
(1) Move glass panel to the fully closed position.
(2)
Disconnect the control switch and wire connector.
(3) Remove headliner as necessary.
(4) Remove side kick cowl panel.
(5) Disconnect drain hose clips from body holes
(Fig. 7) and/or (Fig. 8).
(6) Drain any liquid from hose connection, if nec-
essary.
(7) Hoses between trim and metal Remove old and
replace with new.
(8) Work the hose back and forth to loosen.
(9) Pull the old hose down and through instrument
panel dragging new hose with it, until end of new
hose is near grommet on side cowl.
(10) Remove drain grommet from sheet metal.
(11) Remove old hose from new hose.
INSTALLATION
(1) Insert end of new hose into drain grommet and
replace grommet into sheet metal.
(2) Attach hose upper clips into holes in sheet
metal.
(3) Engage upper flair end of hose into sunroof
module drain nipple and secure with ratchet clamp.
REAR HOUSING HOSE
REMOVAL
(1) Move glass panel to the fully closed position.
(2)
Disconnect the control switch and wire connector.
(3) Remove headliner as necessary.
(4) Remove rear shelf panel.
Fig. 6 Sunshade Guide Block
1 – GUIDE BLOCK
2 – GUIDE BLOCK SPRING
Fig. 7 Front Left Housing Drain Hose
1 – A-PILLAR
2 – DRAIN HOSE
3 – GROMMET
LH BODY 23 - 27
REMOVAL AND INSTALLATION (Continued)