DOOR LOCK SWITCH
Remove the switch from its mounting location.
Using an ohmmeter, refer to Door Lock Switch Con-
tinuity Test table to determine if continuity is correct
in the LOCK and UNLOCK switch positions. If these
results are not obtained, replace the switch.
DOOR LOCK SYSTEM
For complete testing of the automatic door lock
systems, refer to the proper Body Diagnostic Proce-
dures Manual.
VOLTAGE
The following wiring test sequence determines
whether or not voltage is continuous through the
body harness to switch.
(1) Remove left side switch from door trim panel.
(2) Carefully separate multiple terminal block on
wiring harness from switch body.
(3) Connect one lead of test light to a ground ter-
minal:
• Touch other test light lead to battery feed B+
terminal.
• If test light comes on, the wiring circuit between
the battery and switch is functional.
• If test light does not come on, check fuse 13 in
the Junction Block for a blown fuse. Refer to Group
8W, Wiring Diagrams for circuit information.
REMOVAL AND INSTALLATION
DECK LID RELEASE MOTOR
REMOVAL
(1) Disconnect and isolate the negative battery
cable remote terminal from the remote battery post.
(2) Raise deck lid to the full up position.
(3) Remove latch cover attaching screws then
remove cover.
(4) Remove two mounting motor screws and
remote key cable retainers then remove motor.
INSTALLATION
For installation, reverse the above procedures.
DOOR LOCK MOTOR/LATCH
Refer to Group 23–Body, Front or Rear Door Latch
Removal and Installation.
ADJUSTMENTS
DECK LID
Adjust deck lid latch and striker so that the deck
lid latches with a moderate slam. With ignition
switch in On or Accessory position, push deck lid
unlock switch. Should latch fail to lock or unlock
replace latch assembly.
Fig. 1 Door Lock Motor/Latch
1–RH
2 – + TO LOCK
3–LH
DOOR LOCK SWITCH CONTINUITY TEST
SWITCH
POSITION
CONTINUITY
BETWEEN
RESISTANCE
VALUE
LOCK 1 AND 4 2700 V610%
UNLOCK 1 AND 4 620 V610%
LH POWER LOCK SYSTEMS 8P - 3
DIAGNOSIS AND TESTING (Continued)
To Next Page
Loading...
