(4) Using an ohmmeter, test for continuity between
the terminals of the switch (Fig. 3) as shown in the
Mirror Switch Test table.
(5) If test results are not obtained as shown in the
Mirror Switch Test table, replace the switch.
REMOVAL AND INSTALLATION
MIRROR SWITCH
REMOVAL
(1) Remove the door trim panel. Refer to Group 23,
Body for Removal and Installation procedures.
(2) Disconnect wire connector from back of power
mirror switch.
(3) Disengage lock tabs at both ends of switch and
remove switch from door trim panel.
INSTALLATION
For installation, reverse the above procedures.
MIRROR SWITCH
REMOVAL
(1) Using a trim stick, remove power mirror switch
from mounting position.
(2) Disconnect wire connector.
(3) Remove switch.
INSTALLATION
For installation, reverse the above procedures.
MIRROR SWITCH TEST
SWITCH POSITION
MOVE BUTTON
CONTINUITY BETWEEN
TERMINALS
MIRROR IN “L” POSITION
UP PIN 11 TO 12
PIN 12 TO 13
PIN 9 TO 1
RIGHT PIN 11 TO 1
PIN 9 TO 7
PIN 9 TO 8
DOWN PIN 11 TO 1
PIN 9 TO 12
PIN 9 TO 13
LEFT PIN 11 TO 7
PIN 11 TO 8
PIN 9 TO 1
MIRROR IN “R” POSITION
UP PIN 11 TO 12
PIN 11 TO 13
PIN 9 TO 2
RIGHT PIN 11 TO 6
PIN 9 TO 7
PIN 9 TO 8
DOWN PIN 11 TO 6
PIN 9 TO 12
PIN 9 TO 13
LEFT PIN 11 TO 7
PIN 11 TO 8
PIN 9 TO 6
Fig. 3 Mirror Switch Connector Pin Call-Out
LH POWER MIRROR SYSTEMS 8T - 3
DIAGNOSIS AND TESTING (Continued)
To Next Page
Loading...
