HEADLAMP WASHER NOZZLE
Removal
(1) Hoist vehicle.
(2) Partially remove the front fascia to gain access
to the headlamp assembly. Refer to Group 13, Body
for Removal and Installation procedures.
(3) Remove the headlamp assembly. Refer to
Group 8L, Lamps for Removal and Installation Pro-
cedures.
(4) Remove the headlamp washer nozzle retaining
screws and remove the nozzle from the headlamp
assembly.
Installation
(1) Place the headlamp washer nozzle in position
on the headlamp assembly.
(2) Install the headlamp washer nozzle retaining
screws. Torque to 0.7 to 1.3 N·m.
(3) Reinstall the headlamp assembly. Refer to
Group 8L, Lamps for Removal and Installation Pro-
cedures.
(4) Reinstall the front fascia as necessary. Refer to
Group 13, Body for Removal and Installation Proce-
dures.
(5) Lower vehicle from hoist.
(6) Refill the washer fluid.
(7) Prime the headlamp washer system. Refer to
the Headlamp Priming Procedure in this section.
Fig. 5 Left Side Headlamp Washer Hoses
1 – HEADLAMP WASHER HOSES QUICK DISCONNECT
CONNECTORS
2 – HEADLAMP WASHER HOSES
3 – WINDSHIELD/HEADLAMP WASHER RESERVOIR
Fig. 6 Right Side Headlamp Washer Hoses
1 – HEADLAMP WASHER NOZZLE
2 – HEADLAMP WASHER HOSES QUICK DISCONNECT
CONNECTOR
Fig. 7 Headlamp Washer Nozzle
1 – HEADLAMP WASHER NOZZLE
2 – HEADLAMP WASHER NOZZLE RETAINING SCREWS
3 – HEADLAMP ASSEMBLY
8K - 6 WIPER AND WASHER SYSTEMS LH
REMOVAL AND INSTALLATION (Continued)
2000 LHS, 300M, CONCORDE AND INTREPID
To Next Page
Loading...
