Chrysler 2000 LHS - Removing Braking Disc; Puller Installed on Hub;Bearing Assembly; Hub and Bearing to Stub Axle Retaining Nut

(4) Remove front braking disk (rotor) from hub, by
pulling it straight off wheel mounting studs (Fig. 4).
(5) Remove the speed sensor cable routing bracket
from the strut assembly (Fig. 5).
(6) Remove the hub and bearing to stub axle
retaining nut (Fig. 6).
(7) Install Puller, Special Tool 6790 on hub and
bearing assembly (Fig. 7), using wheel lug nuts to
secure it in place.
Fig. 4 Removing Braking Disc
1 – HUB
2 – STEERING KNUCKLE
3 – BRAKING DISC (ROTOR)
4 – WHEEL MOUNTING STUD
Fig. 5 Speed Sensor Cable Routing Bracket
1 – STRUT ASSEMBLY
2 – ROUTING BRACKET
3 – SCREW
4 – SPEED SENSOR CABLE
Fig. 6 Hub And Bearing To Stub Axle Retaining Nut
1 – HUB/BEARING ASSEMBLY
2 – NUT
Fig. 7 Puller Installed On Hub/Bearing Assembly
LH DIFFERENTIAL AND DRIVELINE 3 - 5
REMOVAL AND INSTALLATION (Continued)