HEADLAMP ALIGNMENT
TABLE OF CONTENTS
page page
SERVICE PROCEDURES
HEADLAMP ALIGNMENT PREPARATION........5
ADJUSTMENTS
HEADLAMP AND FOG LAMP ADJUSTMENT
USING ALIGNMENT SCREEN...............5
SERVICE PROCEDURES
HEADLAMP ALIGNMENT PREPARATION
(1) Verify headlamp dimmer switch and high beam
indicator operation.
(2) Inspect and correct damaged or defective com-
ponents that could interfere with proper headlamp
alignment.
(3) Verify that the headlamp leveling switch is in
the “0” position.
(4) Verify proper tire inflation.
(5) Clean the headlamp lenses.
(6) Verify that the luggage area is not heavily
loaded.
(7) Fuel tank should be FULL. Add 2.94 kg (6.5
lbs.) of weight over the fuel tank for each estimated
gallon of missing fuel.
ADJUSTMENTS
HEADLAMP AND FOG LAMP ADJUSTMENT
USING ALIGNMENT SCREEN
NOTE: 300M vehicle headlamps should be aligned
using the low beams. The high beams should be
used to verify low beam settings.
ALIGNMENT SCREEN PREPARATION
(1) Position vehicle on a level surface perpendicu-
lar to a flat wall 7.62 meters (25 ft.) away from front
of headlamp lens.
(2) If necessary, tape a line on the floor 7.62
meters (25 ft.) away from and parallel to the wall.
(3) From the floor up 1.27 meters (5 ft.), tape a
line on the wall at the center line of the vehicle.
Sight along the center line of the vehicle (from rear
of vehicle forward) to verify accuracy of the line
placement.
LH LAMPS 8L - 5
2000 LHS, 300M, CONCORDE AND INTREPID
To Next Page
Loading...
Need help?
General
