REMOVAL AND INSTALLATION
WHEEL COVER (BOLT-ON)
REMOVE
(1) Remove the three wheel nuts, (Fig. 12) used to
lock the wheel cover to the wheel.
CAUTION: When removing the wheel cover, do not
pry the wheel cover from the wheel. This can result
in damage to the wheel cover. The wheel cover is
removed by pulling it off the wheel by hand.
(2) Grasp the wheel cover at the edges in line with
the remaining installed wheel nuts and pull straight
outward from the wheel. This will pop the wheel
cover retaining tabs (Fig. 13) over the two remaining
wheel nuts, removing the wheel cover from the
wheel.
Fig. 11 Dynamic Unbalance & Balance
1 – CENTER LINE OF SPINDLE
2 – ADD BALANCE WEIGHTS HERE
3 – CORRECTIVE WEIGHT LOCATION
4 – HEAVY SPOT WHEEL SHIMMY AND VIBRATION
Fig. 12 Wheel Cover Locking Nuts
1 – WHEEL
2 – BOLT-ON WHEEL COVER
3 – WHEEL COVER RETAINING WHEEL NUTS
Fig. 13 Wheel Cover Retaining Tabs
1 – WHEEL NUTS
2 – TIRE
3 – WHEEL COVER RETAINING TABS
4 – WHEEL COVER
22 - 12 TIRES AND WHEELS LH
SERVICE PROCEDURES (Continued)
To Next Page
Loading...
