(3) Pull cover over edges of the foam.
(4) Cut hog rings to free cover.
(5) Remove rear seat back cover from seat back.
INSTALLATION
(1)
(1) Position seat back cover on seat back.
(2) Install hog ring on right side listing pocket of
cover to foam, starting in the middle and lining up
the die cuts in the listing pocket with the hog ring
windows in the foam (three places).
(3) Repeat for the left side listing pocket of cover.
(4) Place cover seams in salvage trenches of foam.
(5) Roll corners and edges of cover over foam.
(6) Flip seat over making sure cover is pulled up
over frame on all corners. Push top, bottom, inside,
outside, corners of the foam into the cover and
engage J-strap retainers.
(7) Install rear seat back and rear seat cushion.
REAR SEAT ARM REST – 60/40
REMOVAL
(1) Fold down 40 side rear seat back.
(2) Remove arm rest bolt (Fig. 19).
(3) Remove retaining C-clip.
(4) Remove arm rest.
INSTALLATION
(1) Place arm rest in bracket.
(2) Install arm rest bolt. Tighten to 12 N·m (9 ft.
lbs.) torque.
(3) Install retaining C-clip.
(4) Reposition the seats.
REAR SEAT ARM REST WITH SKI PASS
REMOVAL
(1) Remove rear seat cushion.
(2) Remove nuts attaching rear seat back and belts
to the floor.
(3) Push rear seat back with arm rest and ski pass
upward to disengage hooks at top of seat back (Fig.
20).
(4) Remove silencer panel fasteners on the back of
seat back (Fig. 21).
(5) Remove silencer panel.
(6) Remove fasteners attaching arm rest to seat
back (Fig. 22).
(7) Remove arm rest (Fig. 23).
INSTALLATION
(1) Place arm rest into position.
(2) Install fasteners attaching arm rest to seat
back. Tighten fasteners to 5 N·m (45 in. lbs.) torque.
(3) Install silencer fasteners. Use new fasteners.
(4) Install seat back.
(5) Install seat cushion.
REAR SEAT BACK – 40 SECTION
REMOVAL
(1) Open door.
(2) Remove seat cushion.
(3) Remove nuts attaching seat back collar assem-
bly.
(4) Remove seat back collar assembly (Fig. 24).
(5) Remove bolt attaching 40 section (Fig. 25).
(6) Slide seat back 40 section off pin and remove
from the collar assembly (Fig. 26).
Fig. 18 Rear Seat Back
1 – REAR SEAT BACK MOUNTS
2 – REAR SEAT BACK
3 – REAR SEAT BELTS
Fig. 19 Rear Seat Arm Rest – 60/40
1 – BOLT
2 – RETAINING C-CLIP
LH BODY 23 - 17
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
