LAMP BULB SERVICE
TABLE OF CONTENTS
page page
REMOVAL AND INSTALLATION
HEADLAMP BULB(S) – CONCORDE/LHS/300M . . 12
HEADLAMP BULBS – INTREPID .............12
FOG LAMP BULB – INTREPID/300M ..........13
FOG LAMP BULB – LHS ...................13
FRONT PARKING AND TURN SIGNAL LAMP
BULB-LHS ...........................14
FRONT PARKING, SIDE MARKER, AND TURN
SIGNAL LAMP BULB – CONCORDE .........14
FRONT PARKING, SIDE MARKER, AND TURN
SIGNAL LAMP BULB – INTREPID ...........14
FRONT SIDE MARKER LAMP BULB – LHS .....15
CHMSL BULB(S) – CONCORDE/LHS ..........15
CHMSL AND APPLIQUE LAMP BULB(S) –
INTREPID .............................15
CHMSL LAMP BULB – 300M ................16
TRUNK LAMP BULB.......................16
TAIL, STOP, BACK UP, AND TURN SIGNAL
LAMP BULB ...........................16
LICENSE PLATE LAMP BULB – REAR
BUMPER FASCIA .......................17
REMOVAL AND INSTALLATION
HEADLAMP BULB(S) – CONCORDE/LHS/300M
Headlamp lens fogging is a normal condition
and does not require service unless excessive
or continual. Moisture will vent from tubes or
vents located on the back of the lamp.
REMOVAL
(1) Remove headlamp housing. Refer to Headlamp
Housing - Concorde/LHS/300M for proper procedures.
(2) Rotate retaining ring (High beam or Low beam)
and pull lamp socket from headlamp housing (Fig. 1).
(3) Remove bulb from lamp wiring connector.
INSTALLATION
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(1) Push bulb into lamp wiring connector.
(2) Place lamp socket into headlamp housing and
rotate retaining ring to the lock position.
(3) Install headlamp housing.
HEADLAMP BULBS – INTREPID
Headlamp lens fogging is a normal condition
and does not require service unless excessive
or continual. Moisture will vent from tubes or
vents located on the back of the lamp.
REMOVAL
(1) Release hood latch and open hood.
(2) Remove jackscrews attaching headlamp hous-
ing to crossmember and remove the lamp housing to
access the lamp(s).
(3) Disconnect wire connector from back of lamp
socket (Fig. 2).
(4) Rotate bulb (High beam or Low beam) and pull
from headlamp housing.
INSTALLATION
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(1) Place into headlamp housing and rotate to the
lock position.
(2) Connect wire connector to bulb.
(3) Place lamp housing in position on vehicle.
Fig. 1 Headlamp Bulb Removal
1 – RETAINING RING
2 – WIRE CONNECTOR
3 – BULB
4 – LAMP SOCKET
8L - 12 LAMPS LH
To Next Page
Loading...
