Chrysler 2000 LHS - Accelerator Pedal; Fuel Filler Neck; Fuel Filler Vent Hose

FUEL FILLER NECK
REMOVAL
(1) Disconnect negative cable from battery.
(2) Drain fuel tank.
(3) Remove 3 screws from filler neck to quarter
panel.
(4) Raise and support vehicle on host.
(5) Loosen clamps at filler neck.
(6) Remove filler neck.
INSTALLATION
(1) Install filler neck to filler hose.
(2) Tighten clamps.
(3) Lower vehicle.
(4) Install 3 screws to filler neck and quarter
panel.
(5) Fill tank and check for leaks.
(6) Connect negative cable from battery.
FUEL FILLER VENT HOSE
REMOVAL
(1) Perform fuel system pressure release.
(2) Disconnect negative cable from battery.
(3) Drain fuel tank.
(4) Raise and support vehicle on host.
(5) Lower fuel tank, refer to Fuel Tank Removal/
Installation in this section.
(6) Remove vent hose from top of tank.
(7) Remove vent hose from fuel filler neck.
INSTALLATION
(1) Install vent hose and tighten clamp.
(2) Install fuel tank, refer to Fuel Tank Removal/
Installation in this section.
(3) Install vent hose to fuel filler neck and tighten
clamp.
(4) Lower vehicle.
(5) Fill fuel tank and check for leaks.
(6) Connect negative cable to battery.
ACCELERATOR PEDAL
REMOVAL
(1) Working from the engine compartment, hold
the throttle body throttle lever in the wide open posi-
tion. Remove the throttle cable from the throttle body
cam.
(2) From inside the vehicle, hold up the pedal and
remove the cable retainer and throttle cable from the
upper end of the pedal shaft (Fig. 30) and (Fig. 31).
(3) Working from the passenger compartment,
remove nuts from accelerator pedal base (Fig. 32).
Remove pedal and base from vehicle.
INSTALLATION
(1) Position accelerator pedal assembly over studs
onto dash panel. Ensure carpet and insulation are
trapped between the lip of the pedal base and the
floor plan (Fig. 33). Install mounting nuts and
tighten to 12 N·m (105 in. lbs.) torque.
(2) From inside the vehicle, hold up the pedal and
install the throttle cable and cable retainer in the
upper end of the pedal shaft.
Fig. 28 Fuel Filler Tube
1 – FUEL FILLER TUBE
2 – FUEL TANK
Fig. 29 Fuel and EVAP Lines
1 – EVAP LINES
2 – BRAKE LINES
3 – FUEL LINE
LH FUEL SYSTEM 14 - 17
REMOVAL AND INSTALLATION (Continued)