REMOVAL AND INSTALLATION
AMBIENT TEMPERATURE SENSOR
REMOVAL
(1) Open hood, disconnect and isolate the negative
battery cable remote terminal from the remote bat-
tery post (Fig. 5).
(2) Raise and support vehicle on safety stands.
(3) From behind front bumper fascia, remove
screw attaching sensor to radiator closure panel (Fig.
6).
INSTALLATION
For installation, reverse the above procedures.
BASE UNIT
REMOVAL
(1) Open hood, disconnect and isolate the negative
battery cable remote terminal from the remote bat-
tery post (Fig. 5).
(2) Grasp the both outer sides and pull downward
to disconnect the retaining clips.
(3) Disconnect wire connector and lower the unit.
(4) Remove console from vehicle.
INSTALLATION
For installation, reverse the above procedures.
MAP LAMP
REMOVAL
(1) Open hood, disconnect and isolate the negative
battery cable remote terminal from the remote bat-
tery post (Fig. 5).
(2) Remove overhead console, refer to Console
Removal and Installation procedures in this section.
(3) Remove lamp socket from mounting.
(4) Remove lamp(s). Replace as necessary.
INSTALLATION
For installation, reverse the above procedures.
MINI CONSOLE
REMOVAL
(1) Remove screw from windshield side of console.
Fig. 4 Variance Zone Map
Fig. 5 Negative Battery Cable Remote Terminal
1 – RIGHT STRUT TOWER
2 – AIR CLEANER INLET TUBE
3 – REMOTE TERMINAL
Fig. 6 Ambient Temperature Sensor
LH OVERHEAD CONSOLE SYSTEMS 8V - 5
SERVICE PROCEDURES (Continued)
To Next Page
Loading...
