REMOVAL AND INSTALLATION
SUNROOF EXPRESS MODULE
REMOVAL
(1) Move the glass panel to the fully closed posi-
tion.
(2) Remove A-pillar trim, sun visors, and map
lamp/mini console.
(3) Lower headliner as necessary to gain access to
the sunroof express module.
(4) Disconnect the express module wire harness
connectors. (Fig. 3)
(5) Remove express module screw.
(6) Remove express module from the keyway by
sliding module towards the center of the vehicle.
INSTALLATION
(1) Insert sunroof express module in the keyway
located in the sunroof module and slide the module
outward to lock it into position.
(2) Install the sunroof express module screw.
(3) Connect the wire connectors to the sunroof
express module.
(4) Install the headliner into position.
(5) Install the A-pillar trim, sun visors, and map
lamp/mini console.
(6) Test sunroof operation, adjust if necessary.
SUNROOF GLASS PANEL
REMOVAL
(1) Slide sunshade rearward to the open position.
(2) Move the glass panel to the fully closed posi-
tion.
(3) Remove the four attaching screws (Fig. 2).
(4) Lift off glass panel and remove from vehicle.
INSTALLATION
(1) Position glass panel, centered to opening.
(2) Start the four attaching screws.
(3) Tighten screws.
(4) Verify sunroof operation and alignment. Check
fit and adjust as necessary, refer to Sunroof Glass
Panel Adjustment for proper procedures.
SUNROOF DRIVE MOTOR
REMOVAL
NOTE: The sunroof system is timed from the fac-
tory so that the motor shuts off automatically when
the sunroof window reaches a certain position.
Extreme care must be taken when removing the
motor, timing may be thrown off causing possible
damage to the sunroof system. Anytime the motor
is removed from the sunroof assembly the sunroof
glass panel must be in the FULLY CLOSED POSI-
TION or the unit will be out of time. The drive motor
cannot be reset to the park position after being
removed.
Refer to sunroof timing.
(1) Move glass panel to the fully closed position.
(2) Remove A-pillar trim, sun visors, and map
lamps/mini console.
(3) Disconnect the control switch wire connector.
(4) Remove headliner as necessary to gain access
to sunroof drive motor. Refer to Headlining Removal
and Installation for proper procedures.
(5) Disconnect the drive motor wire harness con-
nectors (Fig. 3).
(6) Remove drive motor fasteners and remove
motor from the sunroof housing (Fig. 1).
1 – SUNSHADE
2 – EXPRESS MODULE
3 – DRIVE MOTOR
4 – FRAME ASSEMBLY
5 – WIND DEFLECTOR
6 – GLASS PANEL
7 – DRAIN CHANNEL
Fig. 2 Sunroof Glass Panel Removal
1 – ATTACHING SCREW
23 - 24 BODY LH
DIAGNOSIS AND TESTING (Continued)
To Next Page
Loading...
