(2) Grasp the front of console and pull downward
to disconnect the retaining clips.
(3) Disconnect wire connectors and lower the con-
sole.
INSTALLATION
For installation, reverse the above procedures.
OVERHEAD TRAVEL INFORMATION SYSTEM
(OTIS) MODULE
REMOVAL
(1) Remove overhead console, refer to Console
Removal and Installation in this section.
(2) Remove mounting screws and release the map
lamp wire connector from the OTIS (Fig. 7).
(3) Remove the OTIS from overhead console.
INSTALLATION
For installation, reverse the above procedures.
Align the OTIS guides on the housing with the
grooves of the console. Make sure the LOOP of wire
that was clipped into the OTIS module housing is
properly clipped into the new module before the con-
sole is placed back into the headliner.
OVERHEAD TRAVEL INFORMATION SYSTEM
(OTIS) LAMP
REMOVAL
(1) Remove overhead console, refer to Console
Removal and Installatioin procedures in this section.
(2) Using a flat blade screwdriver twist out socket/
lamp.
(3) Replace lamp(s) as necessary.
INSTALLATION
For installation, reverse the above procedures.
OVERHEAD CONSOLE BASE PLATE
REMOVAL
(1) Remove overhead console. Refer to Overhead
Console Removal and Installation procedures in this
section.
(2) Remove head liner. Refer to Group 23, Body for
Removal and Installation procedures.
(3) Using an trim stick, remove console base by
disengaging the body clips (Fig. 8).
(4) Remove base from vehicle.
INSTALLATION
For installation, reverse the above procedures.
Fig. 7 OTIS Removal
1 – LAMPS
2 – MOUNTING SCREWS
Fig. 8 Mini Console Base Removal
1 – FRONT
2 – BODY CLIP LOCATIONS
8V - 6 OVERHEAD CONSOLE SYSTEMS LH
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
