(2) Remove the left headlamp assembly and set
aside. Refer to Group 8L-Lamps, Headlamp Housing
(Intrepid) Removal and Installation.
(3) Remove the four retaining bolts to the washer
reservoir (Fig. 9).
(4) Disconnect the pump and sensor wire connec-
tors.
(5) Disconnect the washer hose.
(6) Disconnect the washer filler hose.
(7) Pivot the inboard side of the reservoir forward
and lift out of vehicle.
(8) If replacing the reservoir, you must transfer
the pump and sensor to the new reservoir (Fig. 10).
NOTE: When transferring pump and sensor, make
sure to use a new grommet for proper sealing and
to avoid leaks.
INSTALLATION
(1) Connect washer hose, filler tube, and wire con-
nectors to reservoir.
(2) Install reservoir retaining bolts. Torque bolts to
80 to 124 in. lbs. (9 to 14 N·m).
(3) Reconnect the negative battery cable remote
terminal.
WASHER RESERVOIR FILLER TUBE
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Hoist vehicle.
(3) Remove front fascia as necessary (left side only
and use a 2x4 to prop left edge of fascia away from
body). Refer to Group 23, Body for Removal and
Installation procedures.
(4) Reach up behind the washer reservoir and pull
the filler tube off the rear of the reservoir.
(5) Remove one screw attaching washer reservoir
filler tube to upper radiator support (Fig. 11).
(6) Pull filler tube and hose up through left fender
and remove.
INSTALLATION
For installation, reverse the above procedures.
NOTE: Replace/refill washer fluid after filler tube
replacement.
WASHER RESERVOIR PUMP
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Hoist vehicle.
Fig. 10 Washer Reservoir
1 – RETAINING BOLTS
2 – WASHER RESERVOIR
3 – FLUID LEVEL SENSOR
4 – WASHER FLUID PUMP
Fig. 11 Washer Reservoir Filler Tube
1 – SPEED CONTROL SERVO
2 – WASHER RESERVOIR FILLER TUBE
LH WIPER AND WASHER SYSTEMS 8K - 15
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
