(2) Pull lamp from fender.
(3) Twist the bulb socket 1/4 turn and separate the
bulb socket from the lamp (Fig. 13).
(4) Pull the bulb from the socket.
Installation
(1) Insert the bulb into the socket.
(2) Position the socket in the lamp and twist the
socket 1/4 turn.
(3) Position the lamp into the body opening and
push into place.
TAIL, STOP, BACKUP, FOG LAMP AND TURN
SIGNAL BULBS
Removal
(1) Release the deck lid latch and open the deck
lid.
(2) Remove the tail lamp assembly attaching nuts
(Fig. 14).
(3) Remove the tail lamp assembly from the vehi-
cle (Fig. 15).
(4) Disconnect the tail lamp assembly electrical
connector.
(5) Twist and remove the bulb socket from the tail
lamp assembly (Fig. 16) (Fig. 17).
(6) Pull the bulb from the socket.
Fig. 13 Side Repeater Lamp Socket
1 – BULB SOCKET
2 – REPEATER LAMP
Fig. 14 Tail Lamp Assembly Fasteners
1 – TAIL LAMP ASSEMBLY FASTENERS
Fig. 15 Tail Lamp Assembly
1 – REAR TAIL LAMP ASSEMBLY
8L - 12 LAMPS LH
REMOVAL AND INSTALLATION (Continued)
2000 LHS, 300M, CONCORDE AND INTREPID
To Next Page
Loading...
