FOG LAMP ALIGNMENT
Prepare an alignment screen. Refer to Alignment
Screen Preparation paragraph in this section. A prop-
erly aligned fog lamp will project a pattern on the
alignment screen 100 mm (4 in.) below the fog lamp
center line and straight ahead. To adjust fog lamp
alignment, rotate the alignment screw (Fig. 5), (Fig.
6) or (Fig. 7)
Fig. 4 Fog Lamp Alignment Screen
1 – HORIZONTAL CENTER LINE OF FOG LAMPS
2 – TOP OF FOG LAMP BEAM PATTERN CUT OFF 6 4 INS.
FROM HORIZONTAL CENTER LINE
3 – FRONT OF FOG LAMP
4 – 7.62 METERS (25 FT.)
Fig. 3 Headlamp Alignment Screws – Intrepid
1 – HORIZONTAL ADJUSTER
2 – VERTICAL ADJUSTER
Fig. 5 Fog lamp Adjuster Screw – Intrepid
1 – FOG LAMP
2 – UP/DOWN ADJUSTER SCREW
8L - 10 LAMPS LH
ADJUSTMENTS (Continued)
To Next Page
Loading...
