Chrysler 2000 LHS - Battery Cable; Fuel Tank Drain; Stabilizer Bar and EVAP Canister

INSTALLATION
(1) Raise the fuel tank on the transmission stand.
(2) Install fuel pump electrical connector into hole
in the body.
(3) Connect the purge and vent lines.
(4) Raise tank into position and install tank
straps.
(5) Install the fuel filler tube and tighten the
clamp.
(6) Reposition the stabilizer bar and install bolts.
(7) Lower vehicle.
(8) Connect the fuel pump electrical connector that
is in the rear seat.
(9) Install the rear seat.
(10) Connect the battery cable.
(11) Fill fuel tank. Use the DRB scan tool to pres-
surize the fuel system. Check for leaks.
Fig. 24 Battery Cable
1 – BATTERY CABLE
2 – SERVICE VACUUM SUPPLY TEE
Fig. 25 Fuel Tank Drain
1 – FUEL TANK DRAIN
Fig. 26 Stabilizer Bar
1 – FILLER TUBE
2 – MUFFLER
3 – FUEL TANK
Fig. 27 Stabilizer Bar and EVAP Canister
1 – FUEL TANK
2 – EVAP CANISTER
14 - 16 FUEL SYSTEM LH
REMOVAL AND INSTALLATION (Continued)