(7) Apply a thin layer of conductive epoxy on ter-
minal and place terminal on desired location. To pre-
vent terminal from moving while the epoxy is curing,
it must be wedged or clamped.
(8) Carefully remove masking tape from grid line.
CAUTION: Do not allow the glass surface to exceed
204°C (400°F), glass may fracture.
(9) Allow epoxy to cure 24 hours at room tempera-
ture or use heat gun with a 260°-371°C (500°-700°F)
range for 15 minutes. Hold gun approximately 254
mm (10 inches) from repaired area.
(10) After conductive epoxy is properly cured
remove wedge from terminal and check out operation
of rear window defogger. Do not attach connectors
until curing is complete.
WARNING: REPAIR KIT MAY CAUSE SKIN OR EYE
IRRITATION. CONTAINS EPOXY RESIN AND AMINE
TYPE HARDENER, HARMFUL IF SWALLOWED.
AVOID CONTACT WITH SKIN AND EYES. FOR SKIN,
WASH AFFECTED AREAS WITH SOAP AND WATER.
DO NOT TAKE INTERNALLY. IF TAKEN INTER-
NALLY, INDUCE VOMITING; CALL A PHYSICIAN
IMMEDIATELY. IF IN CONTACT WITH EYES, FLUSH
WITH PLENTY OF WATER. USE WITH ADEQUATE
VENTILATION. DO NOT USE NEAR FIRE OR FLAME.
CONTENTS CONTAIN 3 PERCENT FLAMMABLE
SOLVENTS.
KEEP OUT OF REACH OF CHILDREN.
REMOVAL AND INSTALLATION
HEATER-A/C ATC CONTROL
Refer to Group 8E, Instrument Panel and Systems
for proper Removal and Installation procedures.
REAR WINDOW DEFOGGER RELAY
REMOVAL
(1) Disconnect battery negative remote cable from
remote ground post (Fig. 6).
(2) Open trunk. Reach behind trunk carpet and
pull out on relay.
(3) Remove relay from vehicle.
INSTALLATION
For installation, reverse the above procedures.
Fig. 5 Grid Line Repair
1 – BREAK
2 – GRID LINE
3 – MASKING TAPE
Fig. 6 Negative Battery Cable Remote Terminal
1 – RIGHT STRUT TOWER
2 – AIR CLEANER INLET TUBE
3 – REMOTE TERMINAL
LH ELECTRICALLY HEATED SYSTEMS 8N - 5
SERVICE PROCEDURES (Continued)
To Next Page
Loading...
