Chrysler 2000 LHS - Windshield;Headlamp Washer Reservoir Filler Tube; Windshield;Headlamp Washer Reservoir

REMOVAL AND INSTALLATION
WINDSHIELD/HEADLAMP WASHER
RESERVOIR
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Hoist vehicle.
(3) Drain washer fluid into a clean container.
(4) Partially remove the front fascia to gain access
to the windshield/headlamp washer reservoir. Refer
to Group 23, Body for Removal and Installation pro-
cedures.
(5) Disconnect the wire connectors from the wind-
shield washer pump, headlamp washer pump, and
the washer fluid level sensor.
(6) Disconnect the windshield washer pump and
the headlamp washer pump hoses.
(7) Reach up behind the washer reservoir and pull
the filler tube off the rear of the reservoir.
(8) Remove the four mounting bolts to washer res-
ervoir (Fig. 1).
(9) Remove the washer reservoir from vehicle.
(10) Transfer the washer fluid level sensor, head-
lamp washer pump, and the windshield washer
pump to the new reservoir (Fig. 2).
INSTALLATION
(1) Connect the windshield washer pump hose,
headlamp washer pump hose, filler tube, and the
wire connectors to reservoir.
(2) Install the reservoir retaining bolts. Torque
bolts to 5 to 7 N·m.
(3) Reinstall the front fascia as necessary. Refer to
Group 23, Body for Removal and Installation proce-
dures.
(4) Reconnect the negative battery cable remote
terminal.
(5) Lower vehicle from hoist.
(6) Refill the windshield/headlamp washer reser-
voir.
(7) Reconnect the negative battery cable at the
remote battery post.
(8) Prime the headlamp washer system. Refer to
the Headlamp Washer Priming Procedure in this sec-
tion.
WINDSHIELD/HEADLAMP WASHER
RESERVOIR FILLER TUBE
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Hoist vehicle.
(3) Drain washer fluid into a clean container.
Fig. 1 Windshield/Headlamp Washer Reservoir
Removal
1 – WASHER RESERVOIR FILLER TUBE
2 – WASHER RESERVOIR
Fig. 2 Windshield/Headlamp Washer Reservoir
1 – RETAINING BOLTS
2 – WASHER RESERVOIR
3 – FLUID LEVEL SENSOR
4 – WASHER FLUID PUMP
8K - 4 WIPER AND WASHER SYSTEMS LH
2000 LHS, 300M, CONCORDE AND INTREPID