LAMPS
TABLE OF CONTENTS
page page
LAMP SYSTEMS...........................1
HEADLAMP ALIGNMENT .................... 5
LAMP BULB SERVICE ...................... 8
LAMP SERVICE........................... 15
BULB APPLICATION ....................... 20
LAMP SYSTEMS
DESCRIPTION AND OPERATION
HEADLAMP LEVELING SYSTEM
This vehicle is equipped with a remote headlamp
leveling system. This system allows the driver to
adjust the vertical headlamp aim from the interior of
the vehicle to compensate for passenger or cargo
load. A headlamp leveling switch is located on the
instrument panel and controls the headlamp leveling
motors found on the backs of the headlamp modules.
DIAGNOSIS AND TESTING
SAFETY PRECAUTIONS
WARNING: EYE PROTECTION SHOULD BE USED
WHEN SERVICING GLASS COMPONENTS. PER-
SONAL INJURY CAN RESULT.
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
Do not use bulbs with higher candle power than
indicated in the Bulb Application table at the end of
this group. Damage to lamp and/or Daytime Run-
ning Lamp Module can result.
Do not use fuses, circuit breakers or relays hav-
ing greater amperage value than indicated on the
fuse panel or in the Owners Manual.
When it is necessary to remove components to ser-
vice another, it should not be necessary to apply
excessive force or bend a component to remove it.
Before damaging a trim component, verify hidden
fasteners or captured edges are not holding the com-
ponent in place.
DIAGNOSTIC PROCEDURES
When a vehicle experiences problems with the
headlamp system, verify the condition of the battery
connections, charging system, headlamp bulbs, wire
connectors, relay, high beam dimmer switch and
headlamp switch. Refer to Group 8W, Wiring Dia-
grams, for component locations and circuit informa-
tion.
LH LAMPS 8L - 1
2000 LHS, 300M, CONCORDE AND INTREPID
To Next Page
Loading...
