(6) Connect wire connectors and install the cush-
ion side shields.
(7) Install front seat in vehicle.
REAR SEAT CUSHION
NOTE: Fabric covered cushions are serviced as an
assembly.
REMOVAL
(1) Pull upward at forward edge of cushion each
retainer loop of the rear seat cushion to disengage
retainer loops from cups in floor (Fig. 17).
(2) Guild seat belts through loops.
(3) Remove rear seat cushion from vehicle.
INSTALLATION
(1) Place rear seat cushion in position.
(2) Guild seat belts through loops.
(3) Engage retainer loops into cup on floor kick-up.
(4) Push downward at forward edge at each
retainer loop of the rear seat cushion to engage
retainers.
REAR SEAT BACK
REMOVAL
(1) Remove rear seat cushion.
(2) Remove nuts attaching rear seat back and belts
to floor (Fig. 18).
(3) Pull bottom of seat back out to slide rear seat
back mounts off studs. Push rear seat back upward
to disengage hooks at top of seat back.
(4) Remove rear seat from vehicle.
INSTALLATION
(1) Place rear seat in position in vehicle.
(2) Engage hooks at top of seat back.
(3) Install nuts attaching rear seat back and belts
to floor. Tighten to 40 N·m (29 ft. lbs.) torque.
(4) Ensure inboard seat belts are pushed through
elastic straps at bottom edge of seat back.
(5) Install rear seat cushion.
REAR SEAT BACK COVER FIXED SEAT BACK
REMOVAL
(1) Remove rear seat cushion.
(2) Remove rear seat back.
Fig. 15 Recliner Pivot Bolt
1 – RECLINER BOLT
Fig. 16 Front Seat Track – Typical
1 – ATTACHING BOLTS
Fig. 17 Rear Seat Cushion
1 – RETAINER LOOP
2 – REAR SEAT BACK
3 – REAR SEAT CUSHION
4 – CUPS
23 - 16 BODY LH
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
