(2) Remove the fuse panel cover from the left end
of the instrument panel (Fig. 3).
(3) Remove the 2 screws behind the fuse panel
cover attaching the lower instrument panel cover to
the instrument panel (Fig. 4).
(4) Remove the lower instrument panel cover. The
lower instrument panel cover is attached by retain-
ing clips along the top and right edge.
(5) Remove the wiring harness connector from the
trunk release switch in the lower instrument panel
cover (Fig. 5).
(6) Remove the parking brake release cable, from
the park brake release handle in the lower instru-
ment panel cover (Fig. 6).
(7) Remove the 4 bolts (Fig. 7) mounting the rein-
forcement (Fig. 7) to the instrument panel. Remove
the reinforcement from the instrument panel.
Remove the diagnostic connector (Fig. 8) from the
reinforcement.
(8) Before beginning removal of steering column
assembly from vehicle, be sure front wheels of vehicle
are in the STRAIGHT-AHEAD position.
(9) Remove the speed control switches (Fig. 9)
from the steering wheel. The speed control switches
Fig. 3 Fuse Panel Cover
1 – FUSE PANEL COVER
2 – INSTRUMENT PANEL
Fig. 4 Lower Instrument Panel Cover Mounting
Screws
1 – MOUNTING SCREWS
2 – INSTRUMENT PANEL BRACKET
3 – LOWER INSTRUMENT PANEL COVER
Fig. 5 Trunk Release Wiring
1 – WIRING HARNESS CONNECTOR
2 – TRUNK RELEASE SWITCH
3 – LOWER INSTRUMENT PANEL COVER
Fig. 6 Park Brake Release Cable
1 – PARK BRAKE RELEASE CABLE
2 – PARK BRAKE RELEASE HANDLE
3 – LOWER INSTRUMENT PANEL COVER
19 - 48 STEERING LH
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
