Chrysler 2000 LHS - Page 1255

(9) Remove OD shaft/hub and OD clutch pack (Fig.
233) (Fig. 234).
NOTE: Tag overdrive clutch pack for reassembly
identification.
(10) Remove and inspect #3 & #4 thrust washers
(Fig. 235).
(11) Remove the underdrive shaft assembly (Fig.
236).
(12) Remove the #2 needle bearing (Fig. 237).
Fig. 232 Waved Snap Ring
1 – OVERDRIVE SHAFT ASSEMBLY
2 – OD/REVERSE CLUTCH WAVED SNAP RING
3 – SCREWDRIVER
Fig. 233 Remove OD Clutch Pack
1 – OVERDRIVE SHAFT ASSEMBLY AND OD CLUTCH PACK
2 – #3 THRUST PLATE
3 – #3 THRUST WASHER
4 – UNDERDRIVE SHAFT ASSEMBLY
Fig. 234 Overdrive Clutch Pack
1 – OVERDRIVE CLUTCH PLATE
2 – OVERDRIVE SHAFT ASSEMBLY
3 – OVERDRIVE CLUTCH DISC
Fig. 235 #3&4 Thrust Washers
1 – #3 THRUST PLATE (3 TABS)
2 – OD SHAFT ASSEMBLY
3 – #4 THRUST PLATE (3 SLOTS)
21 - 86 42LE TRANSAXLE LH
DISASSEMBLY AND ASSEMBLY (Continued)