CAUTION: Driveshaft retainer clips and seals
located on the stub shafts must be replaced before
reinstalling driveshafts.
Fig. 369 Install Chain Spreader
1 – OUTPUT SPROCKET
2 – SPECIAL TOOL 6550
3 – TRANSFER SPROCKET
Fig. 370 Remove Chains and Sprockets as an
Assembly
1 – CHAINS
Fig. 371 Remove Long Stub Shaft Snap Ring
1 – SNAP RING
2 – SNAP RING PLIERS
3 – LONG STUB SHAFT
Fig. 372 Remove Long Stub Shaft
1 – LONG STUB SHAFT
2 – SPECIAL TOOL 6669
3 – SLIDE HAMMER C-3752
LH 42LE TRANSAXLE 21 - 121
DISASSEMBLY AND ASSEMBLY (Continued)
To Next Page
Loading...
