Chrysler 2000 LHS - Page 1392

fenders and flush across the top surfaces along fend-
ers.
(6) Remove support from under hood and verify
hood operation.
COWL SCREEN
REMOVAL
(1) Release hood latch and open hood.
(2) Remove wiper arms. Refer to Group 8K, Wind-
shield Wiper and Washer Systems.
(3) Remove screws attaching cowl screen at the
windshield and under hood (Fig. 26).
(4) Remove cowl screen from vehicle.
INSTALLATION
(1) Place cowl screen in position on vehicle.
(2) Install cowl screen screws, starting at fender
moving inboard.
(3) Install wiper arms. Refer to Group 8K, Wind-
shield Wiper and Washer Systems.
GRILLE - CONCORDE
REMOVAL
(1) Open hood.
(2) Remove fascia.
(3) Remove two screws attaching foam.
(4) Remove ten attaching grille clips.
(5) Remove grille.
INSTALLATION
(1) Place grille into position on vehicle.
(2) Install ten attaching grille clips.
(3) Install two screws attaching foam.
(4) Install fascia.
(5) Close hood and check alignment of the grille.
GRILLE - UPPER - 300M
REMOVAL
(1) Open hood.
(2) Remove fascia.
(3) Drill out rivets attaching cross bracket to
grille.
(4) Remove upper grille six attaching clips.
(5) Remove grille.
INSTALLATION
(1) Place grille into position on vehicle.
(2) Install six attaching grille clips.
(3) Install rivets attaching cross bracket to grille.
(4) Install two screws attaching foam.
(5) Install fascia.
(6) Close hood and check alignment of the grille.
Fig. 25 Hood Hinge
1 – HOOD
2 – HOOD HINGE
3 – GAS PROP
Fig. 26 Cowl Screen
1 – PLENUM COWL SCREEN
2 – COWL SCREEN RIGHT
3 – COWL SCREEN LEFT
LH BODY 23 - 41
REMOVAL AND INSTALLATION (Continued)