(4) Remove three screws from the bottom edge of
door (Fig. 47).
(5) Using an trim tool, disengage the retaining
clips from the door trim panel to the door panel. Two
clips at the rear of panel and one at the front of the
panel (Fig. 48).
(6) Raise trim panel up over the door flange and
being careful to hold the panel securely.
(7) Disconnect the remote linkage from the door
remote handle.
(8) Remove the wire connect from the rear door
speaker.
(9)
Disconnect power window switch wire connector.
(10) Disconnect wiring harness clips from the trim
panel.
(11) Disconnect the courtesy lamp.
(12) Remove trim panel from door.
INSTALLATION
(1) Place trim panel in position on door.
(2) Connect the courtesy lamp.
(3) Connect the wiring harness clips to the trim
panel.
(4) Connect the power window switch wire harness
connector.
(5) Connect the rear door speaker wire connect.
(6) Connect the remote handle linkage.
(7) Install the water shield. Ensure that the water
shield locator holes align. Ensure that the shield is
sealed.
(8) Place trim panel into channel retainer at top
door.
(9) Insert trim panel into channel retainer at top
door.
(10) Insert the forward four way alignment guide
into position. Insert the rearward two way alignment
guide into position.
(11) Install new retaining clips to attach door trim
panel to door panel.
(12) Engage retaining clips attach door trim panel
to door panel.
(13) Install three screws to the bottom of the door.
Tighten screws 1.7 to 2.3 N·m (15 to 20 in. lbs.)
torque.
(14) Install screw in the remote bezel.
(15) Install screw in pull cup. Tighten screw 1.7 to
2.3 N·m (15 to 20 in. lbs.) torque.
(16) Install pull cup and remote bezel trim plug, if
equipped.
REAR DOOR LATCH
REMOVAL
(1) Close door glass.
(2) Remove door trim panel.
(3) Remove rear glass channel.
(4) Disconnect lock button link from door latch.
(5) Disconnect outside door handle link from door
latch.
(6) Remove screws attaching door latch to door end
frame (Fig. 49).
(7) Remove latch from door.
Fig. 47 Rear Door Trim Panel – Typical
1 – REMOTE BEZEL
2 – PULL CUP
3 – SCREWS
Fig. 48 Rear Door Inner Trim Panel – Typical
1 – REAR DOOR SPEAKER
2 – POWER WINDOW SWITCH
3 – RETAINER CLIPS
4 – COURTESY LAMP
23 - 52 BODY LH
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
