should be replaced if there is excessive wear or scor-
ing. If the friction surfaces are oily, inspect the shaft
nose area of the compressor for oil and remove the
felt from the front cover. If the compressor felt is sat-
urated with oil, the shaft seal is leaking and will
have to be replaced.
(7) Check bearing for roughness or excessive leak-
age of grease. Replace bearing as required.
INSTALLATION
(1) Align pin in back of field coil with hole in com-
pressor end housing, and position field coil into place.
Fig. 18 Compressor Shaft Bolt and Clutch Plate
1 – COMPRESSOR SHAFT BOLT
2 – COMPRESSOR CLUTCH PLATE
Fig. 19 Clutch Plate and Shim(s)
1 – COMPRESSOR SHAFT
2 – CLUTCH PLATE
3 – CLUTCH PLATE SHIM
Fig. 20 Removing Pulley Snap Ring
1 – SNAP RING
Fig. 21 Clutch Coil Snap Ring
1 – SNAP RING PLIERS
2 – CLUTCH COIL
3 – SNAP RING
4 – COMPRESSOR
24 - 20 HEATING AND AIR CONDITIONING LH
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
