INSTALLATION
For installation, reverse the above procedures. Be
sure that the wire connectors are facing forward in
vehicle.
REAR WINDOW ANTENNA (CONCORDE, LHS,
and 300M)
To replace the rear window antenna the rear win-
dow has to be replaced. Refer to Group 23, Body for
proper procedures.
REAR WINDOW ANTENNA MODULE
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 6).
(2) Remove right upper quarter trim panel. Refer
to Group 23, Body for Removal and Installation pro-
cedures.
(3) Remove the attaching screw from module.
(4) Disconnect wire connectors and radio antenna
coaxial cable (Fig. 4).
(5) Remove module from vehicle.
INSTALLATION
For installation, reverse the above procedures.
REMOTE AMPLIFIER
REMOVAL - MIDLINE AND INFINITY l SYSTEM
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 6).
(2) Remove right under panel silencer/duct. Refer
to Group 8E, Instrument Panel and Systems for
Removal and Installation procedures.
(3) Remove two retaining nuts to remote amplifier.
(4) Pull amplifier inboard and then pull downward
to remove from upper retaining clips (Fig. 2).
(5) Disconnect two wiring connectors.
(6) Remove remote amplifier from vehicle.
INSTALLATION
For installation, reverse the above procedures.
REMOVAL - INFINITY ll SYSTEM
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 6).
(2) Inside trunk, pull the trunk liner aside (right
quarter panel passenger side) (Fig. 3).
(3) Remove three retaining screws.
(4) Disconnect two wire connectors.
(5) Remove remote amplifier from vehicle.
INSTALLATION
For installation, reverse the above procedures.
LH AUDIO SYSTEMS 8F - 19
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
Need help?
General
