REMOVAL AND INSTALLATION
COMBINATION FLASHER
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 5).
(2) Remove the left under panel silencer duct.
(3) The flasher can be removed by pulling in a
rearward direction.
INSTALLATION
For installation, reverse the above procedures.
MULTI-FUNCTION SWITCH
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Remove tilt lever.
(3) Remove both upper and lower steering column
shrouds.
(4) Remove multi-function switch mounting screws
and connectors (Fig. 6).
INSTALLATION
For installation, reverse the above procedures.
(1) Tighten multi-function switch retaining screws
to 17 in. lbs. (2 N·m) torque.
Fig. 5 Negative Battery Cable Remote Terminal
1 – RIGHT STRUT TOWER
2 – AIR CLEANER INLET TUBE
3 – REMOTE TERMINAL
Fig. 6 Multi-Function Switch
1 – MULTIFUNCTION SWITCH
2 – MOUNTING SCREW
3 – WIRING HARNESS
4 – STEERING COLUMN
5 – MOUNTING SCREW
LH TURN SIGNAL AND HAZARD WARNING SYSTEMS 8J - 5
To Next Page
Loading...
