Chrysler 2000 LHS - Page 393

HEADLAMP LEVELING MOTOR
REMOVAL
(1) Remove the headlamp assembly from the vehi-
cle. Refer to the procedure in this group.
(2) Disconnect the headlamp leveling motor wire
connector.
(3) Place the headlamp assembly on a protective
surface to prevent damage the lens.
(4) Grasp the leveling motor and rotate approxi-
mately 45 degrees to unlatch it from the lamp hous-
ing.
(5) Using an appropriate prying tool, place the
edge of tool between leveling motor gasket and head-
lamp assembly. Pry the leveling motor up and out.
CAUTION: BE CERTAIN NOT TO DAMAGE THE
LAMP HOUSING SEALING SURFACE.
INSTALLATION
(1) Be certain replacement motor matches the con-
figuration of the motor removed.
(2) Line up lugs on new motor with the corre-
sponding openings on the headlamp housing making
sure the ball stud on the motor lines up with ball
stud receptacle on the lamp assembly. The receptacle
can be moved by grasping the rubber boot area of the
outboard lamp and moving by hand. Rotate the
motor back into position to secure in place.
(3) Push down on outboard lamp until leveling
motor ball stud snaps into place. Ensure that the ball
stud is fully seated.
(4) Connect the headlamp leveling motor wire con-
nector.
(5) Install the headlamp assembly on the vehicle.
Refer to the procedure in this group.
(6) Verify headlamp leveling motor operation.
(7) Align the headlamps. Refer to the procedure in
this group.
NOTE: Headlamps must be aligned with the head-
lamp leveling switch in the “0” position
FRONT FOG LAMP
Removal
(1) Remove the front fog lamp attaching screws
(Fig. 3).
(2) Pull the fog lamp assembly from the bumper
fascia and disconnect the electrical connector (Fig. 4).
Installation
(1) Connect the electrical connector and place the
fog lamp assembly into the front bumper fascia.
(2) Install the fog lamp assembly attaching screws.
Fig. 3 Front Fog Lamp
1 – FRONT FOG LAMP ATTACHING SCREWS
2 – FRONT FOG LAMP ASSEMBLY
3 – FRONT BUMPER FASCIA
Fig. 4 Front Fog Lamp Electrical Connector
1 – FRONT FOG LAMP ASSEMBLY
2 – ELECTRICAL CONNECTOR
8L - 16 LAMPS LH
REMOVAL AND INSTALLATION (Continued)
2000 LHS, 300M, CONCORDE AND INTREPID