Chrysler 2000 LHS - Page 475

MEMORY SELECTOR SWITCH
DESCRIPTION
The memory selector switches are mounted on the
cushion cover side shield of the driver eat within
easy reach of the driver. They provide a means to set
and recall either of the two positions of seat and
recliner, and the side view mirror as chosen by the
driver.
OPERATION
The proper procedure of setting and recalling a
memory position using the memory switches is as fol-
lows:
(1) Adjust the seat, recliner and side view mirrors
to the desired position.
(2) Press momentarily and release memory switch
S.
(3) Press momentarily and release memory switch
1or2.
(4) To program the second driver’s position, repeat
the above procedure using the remaining memory
switch.
(5) To recall either of the programmed positions
momentarily press and release either memory selec-
tor switch 1 or 2.
DIAGNOSIS AND TESTING
GLIDE FEATURE
If seat isn’t sliding forward properly:
(1) First use the DRB scan tool to check whether
glide feature is enabled or not. Enable glide feature if
disabled, and go to Step 2.
(2) Turn the ignition ON and then back OFF.
Remove the key. If seat glides rearward, reinsert key
and turn to ON position. If seat doesn’t glide for-
ward, go to Step 3, otherwise the problem has been
fixed. If Learn Guard Bands test has been run and
problem persists, then replace MHSMM.
(3) Now run Learn Guard Bands Diagnostic test as
shown in this section, and go through Step 2 again.
SERVICE PROCEDURES
REMOTE KEYLESS ENTRY (RKE)
The MHSMM interfaces with the RKE vial the
Programmable Communication Interface (PCI) bus.
The proper procedure of setting and recalling a mem-
ory position using the RKE is as follows:
(1) Press memory switch 1 and release to recall
memory position 1.
(2) Adjust the seat, recliner and side view mirrors
to the desired position.
(3) Press momentarily and release memory switch
S.
(4) Press momentarily and release memory switch
1or2.
Fig. 1 Memory Selector Switch
Fig. 2 Memory Selector Switch Location
1 – MEMORY SELECTOR SWITCH
2 – DRIVER POSITION SET
3 – HEATED SEAT SWITCH
4 – LED’S
5 – DRIVER POSITION
8R - 8 POWER SEAT SYSTEMS LH
DESCRIPTION AND OPERATION (Continued)
2000 LHS, 300M, CONCORDE AND INTREPID